If you are looking to hook up the appliances at home to the existing gas connections, either contact the suitable vendor or follow the do it yourself route. The latter is not an easy task because Gas installation process is prone to leakage and may cause more harm than good in the long run. If you want to facilitate seamless connectivity to the heater, use the following steps to get the desired results.
Conduct research:
Prior to starting the project, you should conduct extensive research in order to carry out the installation process in a hassle-free manner. It is extremely important to understand the intricate details of the device so that no leakages occur during the process. Some incidents in the past are evidence, where people tried to connect the appliances to the line but were unsuccessful, and the effort led to accidents as well as injuries. You should follow the instructions carefully to ward off any problem.
Pull the range:
One of the most important aspects of installation is the pulling out the range and switching off the gas cock. It is a vital step to ensure the safety of the people in close vicinity. Position the lever to the right angle of the pipe to stop the flow of the fuel. Shut off tool is located right in the basement. Therefore, you can easily accomplish the task without any delay.
Hooking up a gas range is a simple process that can be easily done at home. If you are calling the professionals to complete the job, the whole process may set you back by at least 100 dollars.
Purchase connector:
It is important to purchase the connector marked for the desired appliance. For instance, if you are running a heater, a corrugated tube of the connector should be 0.5 inches in diameter. In fact, the dryer connector is not more than 0.375 inches in diameter. Follow the configuration process mentioned in detail on the pack.
One of the most important factors to take into account is the buying of the device with end connector fittings. They are durable and do not leak even when subjected to regular usage over a long period of time. Suitable fitting dimension is essential for compatibility with the main line gas pipe.
Connecting to steel gas pipes:
Connecting to steel gas installation pipes require different skill sets. However, it is also possible to do the same at home. You should buy a completely new gas appliance connecting kit to replace the old steel pie with a flexible stainless steel tube. It is strong, lightweight, and has a long shelf life. It is important to remember that the flare fitting cannot be directly connected to the steel pipe.
Prior to installation, one should also replace the old valves with the modern ball valves. However, to complete the job switch off the main gas supply. Make sure that the leakage does not occur or else, it may lead to tragic accidents.
Connecting to the copper pipe:
A special flaring tool is used to flare the end of the soft copper tubing and use the fittings that match the cone-shaped surface. One should cut a soft copper tube of the required length and connect the same with the flare fittings rightly. Make sure that the dimension matches the opening of the gas installation pipe to get desired results.
Essential guidelines:
It is vital to use yellow Teflon tape and not white tape because the latter is thinner and prone to breakage. Test all the joints for the traces of any leak. After completing the task, you can call the inspector to check the quality of the connection to be on a safer side.
